NORPOLE NPPAC12HKM Manual Del Usuario página 9

LOCATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on a level surface to
minimize noise and vibration.
• The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
• The unit should be located at least 12" (30cm) from the
nearest wall to ensure proper air conditioning.
• DO NOT cover the Intakes, Outlets or Remote Signal
Receptor of the unit, as this could cause damage to the unit.
WINDOW INSTALLATION KIT
1. Preparing the Exhaust Hose Assembly:
Press the exhaust hose into the window
slider adaptor and unit adaptor and clamp
with the buckles of the adaptor.
2. Attach the Exhaust Hose Assembly to the Unit:
Align the hook on the Unit Adaptor with the
Hole Seat on the back of the unit and insert
into lower groove, then attach Hook to the
Hole Seat.
3. Prepare the Adjustable Window Slider:
Measure the size of your window opening.
If needed, cut the window slider to the
correct length. You may need both window
sliders, in which case, slide Window Slider
B into Window Slider A, adjust to correct
size, and use the bolt to fasten the window
sliders together.
INSTALLTION
NOTE: Once the Exhaust Hose Assembly and Adjustable Window Slider are prepared, install according
to the type of window you are using.
1
Exhaust Hose
Unit Adaptor
Hook
Adaptor
Type 1: Hung Window Installation
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
9
Exhaust Hose Assembly
Window Slider Adaptor
Hole Seat
Lower Groove
Bolt
Window
Slider A
Cut the adhesive foam seal
A and B strips to the proper
lengths, and attach them to
the window sash and frame
as shown.
Figure 3
Figure 4
Figure 5
Make sure
the adaptor
is inserted
into the lower
groove of the
air outlet.
Figure 6
Window
Slider B