Outside Mount; Operating The Shade - Levolor Fabric Guia De Instalacion

Ocultar thumbs Ver también para Fabric:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: The brackets must be flush against
a flat mounting surface. Do NOT mount brackets
on curved molding.
Center the shade over the window
opening at the desired height.
Mark screw location for each end
bracket, 2 holes per bracket.
— Use a level to ensure all
brackets are aligned.
STEP 2: INSTALLING THE BRACKETS
Pre-drill screw holes using a
pencil marks as a guide.
— If installing brackets into
wood, use supplied screws.
— If installing into drywall or
other, use anchors in
combination with
supplied screws.
Screw in brackets at marked
locations, 2 screws per bracket.
— Bracket with attached circular
mount should be on left side
(idle side).
— Bracket with attached slots should be on right side (motor side).
Ensure all brackets are square with each other.
Slide bracket end cap over bracket on left side to prepare for shade installation.
CAUTION: Be sure the brackets are properly engaged before
!
operating the shade. Failure to do so may result in the shade
falling and possible injury.
8
Motorized Lift Control–Open Roll
" drill bit, using
1
16
Drywall
Drywall
Anchor
Anchor
Bracket
Bracket
Bracket
Bracket
Screw
Screw

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Solar

Tabla de contenido