Connection Of 2 X 6 Kg (5.1 L) And 2 X 25 Kg (21.2 L); Connection Of The Material Reservoirs; Connection Of The Dosper Evo To The Electric Circuit - Dreve Dosper evo Instrucciones De Trabajo

Dosper evo

7.1.2 Connection of 2 x 6 kg (5.1 l) and 2 x 25 kg (21.2 l)

Replace the original caps of the can-
isters by the optionally available con-
nection hoses (see point 9) and fasten
them hand-tight.
Note that each connection hose must
absolutely be used for the same silicone
component again when changing can-
isters in the future.
The other side of the connection hose
can now be connected to the machine
with the help of the adapters. Turn the

7.1.3 Connection of the material reservoirs

The optionally available material reser-
voirs (see point 9) are clear-transparent
containers, marked with two different
colours for distinction. They are con-
nected to the machine with the help
of the pre-assembled quick couplings.
An electronically controlled float lever
avoids the unwanted complete emp-
tying of the reservoirs. To activate
the system connect the plug-in con-

7.2 Connection of the Dosper evo to the electric circuit

Connect the provided power cord to the
respective socket of the machine (3),
28
canisters upside down and position
them above the machine (a compat-
ible support stand is also available (see
point 9)). Press the connection hoses
onto the adapters (5) until they notice-
ably snap into place.
To allow a problem-free flow of the
silicone mass in the Dosper evo, and
in order to avoid the development of
a vacuum in the canisters, pierce tiny
holes into their bottoms.
tacts mounted to the reservoirs with
the respective sockets (4a/4b) of the
machine.
Take off the lids of the reservoirs and fill
in the respective silicone components.
Each of the two reservoirs has a capac-
ity of up to 1.5 l (corresponds to approx.
1.8 kg). Then close with the lids.
then connect to the electric circuit.