Fitting Tools Onto The FLexible Shaft; Changing The Collet Chuck; Notes On Working With Materials/Tools/Speed Range - Parkside PDFW 120 A1 Traducción Del Manual De Instrucciones Original

Fitting tools onto the flexible shaft
♦ Push the black collar
the flexible shaft
that the collet chuck mount
anticlockwise direction. Hold the black collar
in this position.
♦ Use the combination spanner
collet chuck mount
♦ Fit the tool and screw the collet chuck mount
back into place.
♦ Release the black collar

Changing the collet chuck

You can change the collet chuck
diameter of the tool you want to use is different.
♦ Push the black collar
the flexible shaft
that the collet chuck mount
anticlockwise direction. Hold the black collar
in this position.
♦ Use the combination spanner
collet chuck mount
Unscrew the collet chuck mount
♦ Remove the collet chuck
a collet chuck with the desired diameter.
♦ Replace the collet chuck mount
flexible shaft . Screw the collet chuck mount
tight using the combination spanner
♦ Release the black collar
Using the work arbor for cutting discs
♦ Use the screw driver side of the combination
spanner to undo and tighten the screw of the
work arbor for cutting discs
♦ Fit the work arbor for cutting discs
described into the flexible shaft
♦ Use the combination spanner
screw on the work arbor for cutting discs
♦ Fit the desired cutting disc
screw between the two washers.
♦ Use the combination spanner
screw on the work arbor for cutting discs
PDFW 120 A1
all the way back onto
to lock the spindle. Note
is loosened in an
to undo the
on the flexible shaft
.
if the shaft
all the way back onto
to lock the spindle. Note
is loosened in an
to undo the
on the flexible shaft
.
and replace it with
back on the
.
.
.
as
.
to undo the
/ onto the
to tighten the
Use the work arbor for polishing felts
♦ Screw the tip of the work arbor for polishing
felts clockwise into the corresponding hole
in the polishing felts
♦ Fit the work arbor for polishing felts
described into the flexible shaft
Using the work arbor for abrasive belts
.
♦ Push the required abrasive belt
pletely onto the corresponding work arbor for
abrasive belts
♦ Use the combination spanner
screw on the work arbor
abrasive belts.
♦ Fit the work arbor for abrasive belts
described into the flexible shaft
Notes on working with materials/
tools/speed range
■ Never use the appliance for other purposes
and only use original parts/accessories. Using
attachments or accessory tools other than those
.
recommended in the operating instructions can
lead to a risk of injury.
■ Determine the rotational speed range for work-
ing on zinc, zinc alloys, aluminium and copper
by trying it out on test pieces.
■ Use a low rotational speed for work on plastics
and materials with a low melting point.
■ Use a high rotational speed for working on
wood.
■ Carry out cleaning, polishing and buffing work
in the medium speed range.
The following are recommendations only and not
binding. When carrying out practical work, carry
out your own tests to see which tool and which set-
tings are ideal for the material you are working on.
.
.
/ .
as
.
/ com-
/ .
to tighten the
/ to fasten the
/
.
GB│MT
│
as
73 ■