Preparations For Use - Ega Master PRESSMATIC MINI Manual De Instrucciones

Máquina de prensado radial

Ocultar thumbs

Contenido

página de 23

/ 23
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

For making press joints in all standard press

fitting systems on steel pipes, stainless steel pipes,

copper pipes, plastic pipes, composite pipes

Thrust

Pressing power

Electric data

Rapid charger

Dimensions

Weight

Noise information

Vibrations

For use of the pressing tongs, pressing heads and expanding heads for the various pipe connection

systems, the currently valid sales documents are applicable. If the system manufacturer alters components

of pipe connection systems or markets new ones, must be enquired their current application status.

Before connecting the drive unit or the rapid charger, check whether voltage on the rating plate matches

the mains voltage. At work sites, in damp surroundings, in the open or in the case of comparable types of

use, only operate the equipment off the mains using a 30mA fault current protected switch.

The battery supplied and the spare batteries are not charged. Charge the battery before initial operation.

Only use the rapid charger for charging. Once the battery is inserted into the rapid charger, the red

indicator light flashes. After about one hour, the indicator light switches to permanent, meaning the battery

is charged. The battery only reaches its full capacity after several charges.

Pull the mains plug or remove the battery. Only use pressing tongs with a system-specific pressing

contour matching the press fitting system for identify the pressing contour matching the press fitting

system for pressing. Pressing tongs have a letter on both pressing jaws to identify the pressing contour

and a number to identify the size. Consult and comply with the instructions for installation and fitting of the

system's manufacturers. Never use non-matching pressing tongs for pressing work. The press joint could

be unserviceable, and both the machine and the pressing tongs might be damaged.

The drive unit is best placed on a bench or the floor. Installing the pressing tongs is only possible when

the press rollers in are fully retracted. If necessary, set the rotation direction lever to the left and operate

the inching switch, and press the reset button until the press rollers are fully retracted.

Open the tongs shank. To do so, press the locking pin, the tongs shank jumps out under spring loading.

Insert selected pressing tongs. Push home the tongs shank until the locking pin engages. While doing so,

press down the pressure tongs inserted. Do not start the pressing operation except to make a press joint.

Unless counter pressure is applied by the press fitting, the drive unit or pressing tongs will be needlessly

stressed.

Never operate press when the tongs shank is not locked. Risk of fracture!

CARACTERISTICAS TECNICAS