Craftsman 247.88704 Manual Del Operador página 17

rePLaCing aUger PaddLes
The snow thrower auger's rubber paddles are subject to wear and
should be replaced if any signs of excessive wear are present.
CaUtion
Do NOT allow the auger's rubber paddles to wear to the point where
portions of the metal auger itself can come in contact with the pave-
ment. Doing so can result in serious damage to your snow thrower.
To change the rubber paddles, proceed as follows:
1. Remove the existing rubber paddles by unscrewing the self-
tapping screws which secure them to the auger. See Figure 20.
2. Secure the replacement rubber paddles to the auger using the
hardware removed earlier.
To obtain replacement paddles call Sears at 1-800-4-MY-HOME. Ask
for part # 735-04033.
rePLaCing sHaVe PLate
The shave plate is attached to the bottom of the auger housing and
is subject to wear. It should be checked periodically. There are two
wearing edges and the shave plate can be reversed.
1. Remove the four carriage bolts and hex lock nuts which attach it
to the snow thrower housing.
2. Reverse the existing shave plate or install a one, making sure the
new shave plate and making sure the heads of the carriage bolts
are on the inside of the housing.
3. Adjust the shave plate as instructed on page 14.
4. Tighten securely once adjusted.
To obtain a new shave plate, call Sears at 1-800-4-MY-HOME. Ask for
part #731-1033
SERVICE AND MAINTENANCE
Self-Tapping Screws
Figure 20
17