Tv 301Controller Installation; Bottom Mounting - Agilent Technologies TV 301 Serie Manual De Instrucciones

17 Technical Information

TV 301Controller Installation

TV 301Controller Installation

The controller can be mounted in two position:


To install the controller execute the following procedures.

Bottom Mounting

See the following figure.
1
2
3
4
5
6
7
Figure 51
266/282
bottom mounting (as per the complete system)
side mounting.
Turn the pump upside-down;
Screw the 4 fixing studs (provided with the accessories bag) in
the holes on the bottom of pump;
Place the controller on the studs aligning the 4 rubber holes on
the top of the controller case;
Press the controller towards the pump;
Turn the pump again;
Plug the line cord and connect the pump cable to the pump;
Connect the mating connector with the jumper on the interlock
signal to start the pump.
Mounting 1
TV 301 Navigator User Manual / 87-900-946-01 (M)