How To Install Wireless Remote Controller Receiver; Care And Cleaning - Panasonic S-22MU1E5 Instrucciones De Instalación

Acondicionador de aire con sistema vrf - para refrigerante r410a
Ocultar thumbs Ver también para S-22MU1E5:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 171
Hole for ceiling
panel hook
Hook that prevents the
grille from dropping
Fig. 7-24
● With this ceiling panel, the directions of the air-intake grille
lattices when installing multiple units, and the position of
the label showing the company name on the corner panel,
can be changed according to customer requests. However,
the optional wireless receiver kit can only be installed at the
refrigerant-tubing corner of the ceiling unit. (Fig. 7-25)
* The grille can be installed
Locations of air-intake grille hinges
with these hinges facing
Refrigerant tube side
in any of 4 directions.
Optional wireless
Drain pipe
receiver kit
side
* Only this area is
possible for installation.
Electrical component
box for power PCB
Electrical component box for control PCB
Can be installed rotated 90°
Fig. 7-25
7-8. Checking After Installation
● Check that there are no gaps between the unit and the
ceiling panel, or between the ceiling panel and the ceiling
surface.
Gaps may cause water leakage and condensation.
● Check that the wiring is securely connected.
If it is not securely connected, the auto flap will not operate.
("P09" is displayed on the remote controller.) In addition,
water leakage and condensation may occur.
7-9. When Removing the Ceiling Panel for Servicing
When removing the ceiling panel for servicing, remove the air-
intake grille and air filter, disconnect the wiring connector inside
the electrical component box, and then remove the 4 mounting
screws.
7-10. Adjusting the Auto Flap
The air-direction louver on the ceiling panel outlet can be
adjusted as follows.
● Adjust the louver to the desired angle using the remote
controller. The louver also has an automatic air-sweeping
mechanism.
NOT E
● Never attempt to move the louver by hand.
● Proper airflow depends on the location of the air conditioner,
the layout of the room and furniture, etc. If cooling or heating
seems inadequate, try changing the direction of the airflow.
51
8. HOW TO INSTALL WIRELESS REMOTE
CONTROLLER RECEIVER
NOTE
Refer to the Operating Instructions attached to the optional Wire-
less Remote Controller Receiver.
9. APPENDIX
■ Name of Parts
U1 Type (4-WAY CASSETTE)
Water drain
Ceiling panel
(optional)
Air outlet
(4 locations)
Air intake grille
(air intake)
Y1 Type (4-WAY CASSETTE 60X60)
Water drain
Ceiling panel
(optional)
Air outlet
(4 locations)
Air intake grille
(air intake)
T1 Type (CEILING)
Air outlet
Water drain
(Drain pipe can be
connected to either
the left or right side.)
Air intake grille
(air intake)
F1 Type (LOW SILHOUETTE DUCTED)
Bolt anchor
Air outlet duct
Suspension
bolt
Air-outlet grille
Indoor unit
Ceiling material
M1 Type (SLIM LOW STATIC DUCTED)
Rectangular solid duct (optional)
Electrical box
Water drain
Air intake side filter (rear)
E1 Type (HIGH STATIC PRESSURE DUCTED) for 73, 106 & 140
Air intake side
duct flange
(rear)
Water drain
Electrical box
Air outlet side
duct flange
E1 Type (HIGH STATIC PRESSURE DUCTED) for 224 & 280
Air intake
side duct
flange (rear)
Water drain
Air outlet side
duct flange
(2 locations)
Electrical
box

■ Care and Cleaning

WARNING
For safety, be sure to turn the air conditioner off and
also to disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
Air intake and outlet side (Indoor unit)
Clean the air intake and outlet side of the indoor unit with a
vacuum cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
water. When cleaning the air outlet side, be careful not to force
the vanes out of place.
CAUTION
● Never use solvents or harsh chemicals when cleaning
the indoor unit. Do not wipe plastic parts using very hot
water.
● Some metal edges and the fins are sharp and may cause
injury if handled improperly; be especially careful when
you clean these parts.
● The internal coil and other components of outdoor
unit must be cleaned regularly. Consult your dealer or
service center.
52

Publicidad

Tabla de contenido
loading

Tabla de contenido