Installation Procedure - imacon Flextight Progression Guía De Usuario

Hardware ReferenceÑFlextight Progression
12
Setting up the Scanner

Installation Procedure

IMPORTANT: Before you start to set up your scanner, make sure that
your scanner, your computer and all devices connected to the SCSI
chain are switched off. You can damage your equipment if you make or
break SCSI connections to or from units that are turned on.
1. Unpack your scanner and place it on a table near your computer.
Make sure that the location you choose meets all of the require-
ments outlined above for drawer clearance, temperature, stability,
and electromagnetic interference.
2. Keep the packaging material that came with your scannerÑespe-
cially the bubble plastic and cardboard support for the ßatbed (do
not pop the bubbles in the bubble plastic). You must replace this
packaging material if you later need to transport the scanner (see
ÒPreparing the Scanner for TransportÓ on page 37).
3. Locate the connectors in the recessed area located at the back of the
scanner. You will see two SCSI connectors and a standard power
socket (see ÒBack Panel & ConnectorsÓ on page 10).
4. IMPORTANT: On the back of the scanner is a small dial, which is
used for setting the SCSI address for the scanner. Make sure that
each device in your SCSI chain has been assigned a different SCSI
address. If necessary, use small screwdriver adjust the wheel so
that it points to a new address. Use only 1, 2, 3, 4, 5, or 6. Do not use
7, 8, 9, or 0.
Figure 4:
5. Connect a SCSI cable to one of the SCSI connectors on your scan-
ner. Connect the other end of the cable to your computer or to the
last SCSI device in your chain.
6. Make sure your SCSI chain is terminated correctly. This means that
the empty connector on the last device in your SCSI chain must be
SCSI address selector
Imacon Flextight Progression UserÕs Guide