Support Bar Installation - OVE SYDNEY 60 Manual De Instrucciones

1-3. Completely remove the support bar. Place the 2 support bar's anchors (N) back on their wall mark, then mark
their center on the wall.
4-5. Drill a hole on the center marks Using Φ8mm ceramic drill bit and insert the wall anchors (EE) using a rubber
mallet.
6. Fix the center fitting on the support bar's anchors (N) using the screws (DD).
7. Slide again the roller stoppers (M) and the support bar's anchors (N) onto the support bar (D). Then fix the support
bar to the wall.
8. Fix the fixed panel (A) onto the support bar (D) using the brackets (II).
9. Secure the support bar (D) on their anchors using the provided hex screws.

SUPPORT BAR INSTALLATION

7
M
D
1
II
3
5
EE
8
N
II
11
N
GG
A
D
D
2
4
Φ 8mm
6
N
DD
9