Installation - ESAB Multimaster 260 Manual De Instrucciones

SECTION 2
Remove Plug
Cover
2.1

INSTALLATION

ELECTRIC SHOCK CAN KILL! Make sure that all primary input power to the
power source and wire feeder has been disconnected at the wall (line)
disconnect switch or circuit breaker before making the following connec-
tions.
The following instructions are intended to supplement the manuals supplied with
the wire feeder and power source. Be sure to follow all installation, operation and
safety information provided by these manuals.
2.2 Option Mounting and Cable Connections
Refer to Figure 2.
The Multimaster 260 Pulse option mounts to the top front of the power source
enclosure and is supplied with a 10 inch control cable with a 9 pin male connector.
1. Loosen the two sheet metal screws in the top of the MultiMaster 260 cabinet.
2. Remove the plastic plug located in the top panel of the MultiMaster 260.
3. Route the wiring harness through the hole into the wire feeder compartment.
4. Connect the 9 pin plug to the mating receptacle in the wire spool compart-
ment.
5. Slip the MultiMaster 260 Pulse Option Base over the sheet metal screws and
tighten.
Mounts to top
of Power Source
Figure 2 - Connection to Feeder
10
Wiring Harness
INSTALLATION