B - Installation Using L Exible Or Remote Blower - Mounted In A Remote Location - Ducting Through Front Panel Opening; C - Installation Using Inline Or Remote Blower - Ducting Through Left, Right, Below Or Rear; Insert Upper Support Bracket And Attach Support Leg - Thermador Masterpiece Serie Manual De Instalación

I N S T A L L A T I O N
B - Installation using fl exible or remote
blower - mounted in a remote location -
ducting through front panel opening
CAUTION
If l exible blower is mounted as an inline blower: Do not use legs
alone for support. It may be necessary to add extra support for
the l exible blower.
1. Remove hex nuts to remove front panel cover.
2. If blower discharge is down, remove (4) no. 8-32 hex nuts and
electrical panel.
3. Place 6", 8", or 10" (152 mm, 203 mm, or 254 mm) round rough-in
plate (purchase separately) over studs around front panel opening.
4. Tighten hex nuts to secure remote discharge plate in place.
Page 16
C - Installation using in-line or remote
blower - with ducting through left, right,
below or rear
(Requires purchase of 1-7/8" x 19" (48 mm x 483 mm) to 6", 8", or 10"
(152 mm, 203 mm, or 254 mm) round transition. 1-7/8" x 19" (48 mm x 483 mm)
rectangular duct and connection adapters are also available.)
DUCTING OUT RIGHT SIDE OF
HOUSING SHOWN.
1. Use nuts to connect 1-7/8" x 19" (48 mm x 483 mm) rectangular ductwork
connection adapter or 1-7/8" x 19" (48 mm x 483 mm) to 6", 8", or
10" (152 mm, 203 mm, or 254 mm) round transition to housing when
installing ductwork.
Insert upper support brackets and attach
support legs
1. Slide upper suport brackets into slide channel at top left and right of
unit.
2. Attach previously removed support legs to downdraft using one nut
for each leg. Do not tighten nut completely at this time.