Troubleshooting; Safety Information - NSS Enterprises Sidewinder BP 30 Manual Uso Y Mantenimiento

FAULT
The motor-sweeper fails to pick
up large particles of dirt or leaves
traces of dirt behind
Sweeper leaves dust on
floor or dust comes out
from side flaps
Dust comes out of the suction fan
Motor-sweeper throws dirt forwards
The main brush lifts the front flap
Rapid brush wear
Main brush noise different or excessive
The main brush does not turn
Battery does not maintain its charge
Battery discharges quickly
1) Cleaning:
When cleaning and washing the machine, take care when using aggressive detergents, acids, etc.
Follow the instructions provided by the detergent producer, and wear protective clothing if appropriate (e.g. overalls, gloves, goggles,
etc.).
2) Explosive atmosphere:
The machine is not constructed to work in environments where there is a risk that there might be explosive gases, dusts or vapours,
and so its use in an explosive atmosphere is FORBIDDEN.
3) Disposal of harmful substances:
Comply with the laws in force on waste disposal and treatment when disposing of the material collected, the machine filters and spend
material such as batteries, motor oil, etc.
4) Scrapping the machine:
If the machine is scrapped, subdivide the types of materials of which it consists (EEC Directives) according to the disposal method, so
that they can be disposed of in accordance with the laws in force.
Consign hazardous materials such as batteries, spent oils, etc to operators authorized to dispose of these substances.
Sidewinder BP 30

TROUBLESHOOTING

CAUSE
Brush pressure too light
Brush worn
Bristles bent, or string or wire, etc.,
entangled in brush
Filter clogged
Side flaps worn out or broken
Filter torn
Front flap broken
Front flap too long
Excessive brush pressure
Material wound around brush
Drive belt broken
Electrolyte level low
Battery cell burned out
Motor over-loaded
Battery terminals loose
Material entangled in main brush
Bearings seized
Excessive brush pressure
Insufficient charge time
Battery terminals loose or oxidized

SAFETY INFORMATION

CORRECTIVE ACTION
Adjust brush pressure (trace on floor)
Lower or replace brush
Remove string or wire and straighten bristles
in warm water
Clean filter
Replace side flaps
Replace filter
Replace front flap
Replace front flap
Reduce brush pressure (narrower trace)
Remove entangled material
Fit new drive belt
Top up electrolyte level
Replace battery
Check motor current absorption
Check and tighten battery terminals
Remove entangled material
Replace bearings
Reduce brush pressure (narrower trace)
Increase charge time
Clean terminals and tighten
45