Shipping Contents; Assembly; Attach The Blade Fence - Lackmond BEAST5 Manual De Instrucciones

SHIPPING CONTENTS

In the Box
Description (QTY)
B1. Beast5 handheld wet/dry tile saw (1)
B2. 5-inch blade (1)
B3. Blade wrench (1)
B4. T-wrench (1)
B5. Blade Fence
B1
NOTE: The part and hardware names and numbers correspond to those used in Saw Features on page 6
and the Shipping Contents on page 7.

ATTACH THE BLADE FENCE

1. Install the wear-plate wedge clips (H2) as
shown in Figure 5.
2. Attach the wing screws (H1) but do not
tighten.
3. Carefully insert the blade fence (8, B5) so that
the ends of the fence arms slide under the
wedge clips.
NOTE: The blade fence may be inserted and
used upside down or right side up.
When used right side up, the bottom lip of the
fence is lower than the bottom plate of the saw,
enabling you to use the edge of your workpiece
as a guide.
When installed upside down, the bottom of the
fence is level with the bottom plate of the saw,
keeping the bottom plate level to the workpiece
while letting you use any perpendicular surface
as a guide.
4. Tighten the wing screws but do not
overtighten.
UNPACKING
NOTE:
B2
B6

ASSEMBLY

B6. ¼-inch hose with standard hose
connection (1)
B7. 20mm to 5/8-inch bore adapter (1)
In the Hardware Bag
H1. M6 Wing screws (2)
H2. Wear-plate wedge clips (2)
B3
B4
H1
B7
7
7
B5
H2
H1
FIGURE 5
H2
B5