Walter Bio-Circle Maxi 55D600 Manual Del Usuario página 11

DO NOT USE THIS UNIT AS A WASTE DUMP
6. Inspect the grated receptacle (item H see page 5) daily, it should be
emptied of accumulated solid waste and disposed of outside the parts
washer in order to extend the life of the solution.
7. A magnet is located underneath the grated receptacle (item H see page 5)
to separate all the ferrous particles, thus enhancing the bioremediation
process. The magnet should be cleaned periodically with a clean rag to
maintain its efficiency and ensure rapid draining of the sink.
8. This unit is equipped with a damper located underneath the grated
receptacle (item H see page 5) to slow down evaporation. If too much
evaporation occurs, verify that the damper moves freely.
The Bio-Circle™ Parts Cleaning System is designed for removing oil and
9.
grease from parts and then remediating those substances. Any other use of
this system, such as dumping waste oil, is not recommended and will cause
damage to the system.
For stubborn grime and other hard to clean spots, first spray or soak parts
using WALTER CB100™ (53-G163 Ultra powerful Natural Cleaner and
Degreaser (L-155) prior to cleaning with Bio-Circle L™ (L-78), Bio-
Circle™ Ultra (L-148), and Bio-Circle™ Aero (L-161)
DO NOT USE ANY OTHER TYPES OF CLEANERS, as they will reduce
10.
or prevent the bioremediation process and cause malfunctions to
the unit. Also, adding water will considerably reduce the
bioremediation process as well as the solution's ability to
clean.
11. The built-in thermostat has been factory set to maintain an ideal environment
for the bioremediation process as well as preventing skin burns to the user
and damage to the pump. Do not attempt to alter this unit in any way.
12. Condensation will accumulate underneath the sink top. This is normal due to
the temperature of the cleaning solution. Always ensure that the sink is
closed properly and that the gasket underneath the sink is not damaged to
prevent excessive evaporation.
Note: After a power interruption, the machine will restart automatically,
except for the cleaning pump.
solution.
11