Inserting The Argovent Sintering Base - Amann Girrbach ceramill argotherm 2 Modo De Empleo

5.6

Inserting the Argovent Sintering Base

▷ Insert the ceramic tube.
▷ Insert the floor plate.
Fig. 12
▷ Unscrew the six screws on the rear of the fur-
nace and remove the back panel.
Fig. 13
I N S T A L L A T I O N
▷ Thread the hose piece of the Argovent sintering
base through the hole of the rear wall and slide
the sintering base to the stop into the furnace;
if required, apply a light jiggling motion.
The hose piece must completely project out of
the rear side of the furnace.
Fig. 14
NOTE:
The tube can easily break when being bent.
▷ When mounting together, make sure to firmly
hold the sintering base by the connecting port.
E N
47