Reality Leuchten R031-01 Manual De Instrucciones página 6

The air cooler works best in non-polluted areas. Large dust/dirt particles may reduce lifetime of unit
We recommend use only in dry locations. If using in a moist area or environment, take care not to get water on external
areas of the product
If a leak or spill occurs on the surface of device, unplug the air cooler and let it dry for 24 hours Then use as normal.
Do not place in direct sunlight for extended periods of time
If the air cooler is not going to be used for extended periods of time, first empty the water tank, turn the unit on, and set to
highest fan speed for at least 4 hours. This will dry out the filter and inside of your unit
Only use the original power adapter and cord supplied in package
Do not touch the power supply or power cord with wet hands
Unplug the air cooler when cleaning, removing/replacing filter, or moving the device
For best results, place the air cooler on a higher surface like a table or countertop
Do not place the air cooler near a heater or any electrical equipment
Do not place the device in passageways or high traffic areas where there is a possibility of tripping or knocking it over
Do not allow any foreign objects inside the air cooler.
Do not place items on top of the air cooler
Do not block the front and back grilles of the device
Do not turn the device upside down
Do not submerge the air cooler under water or other liquids
Do not place the air cooler near open flames or fire sources
Tips
Place the air cooler on a raised surface such as a table, desk or counter top. This is the best way to cool your personal area
faster
Let the filter absorb water for at least 3 minutes after filling tank and before use. Doing so will get you the coolest air
quicker
Try to stay within a few feet of the air cooler. You'll feel the most benefit when sitting directly in front of it
The air cooler will run for approximately 8 hours on a single fill on Low fan speed. Even if the water tank is empty, the filter
is still damp and the air cooler is still cooling
Setup
I. Place the air cooler on a flat surface.
II. Open the water tank door and fill with water. We recommend a pitcher or measuring cup
III. Plug the USB power adapter into an outlet. Then, insert the larger USB end of the cable into the adapter and the
smaller end into the power port on the back of the air cooler.