Low Water Pressure Installation - Renaware Aqua 3000 LED Manual Del Usuario

Low Water Pressure Installations:
If the Aqua 3 3000 LED is installed in an extremely low water pressure
environment, then the filter housing may not completely fill with water. This will
limit the use of the CMF Cartridge to the height of the water in the filter housing.
To remedy this, we suggest the following:
1. Clean the CMF Cartridge if dirty. (See "Cleaning the CMF Cartridge", steps 1
through 4.)
2. Replace the CMF Cartridge in the filter base and set aside.
3. Invert the filter housing and fill completely with tap water. (Figure 9)
4. Over the sink, place the CMF Cartridge and filter base into the inverted filter
housing.
NOTE: Take care when inverting the CMF Cartridge, as the CMF Cartridge
may be heavy when saturated with water and could fall from the base and
break. Use your fingers to hold the CMF Cartridge in the base until the filter
housing is in place. Some of the water in the filter housing will be displaced
by the CMF Cartridge.
5. Rotate the filter housing in a clockwise direction until it is tightly attached to
the filter base. (Figure 10)
6. Before righting the filter, wipe dry it with a clean towel.
7. Turn on the tap water. Check for leaks.
Figure 9 Figure 10
10