Maintenance; The Flow Meter - Renaware Aqua 3000 LED Manual Del Usuario

6. Place the Aqua 3 3000 LED on
a flat counter surface near the
sink.With the water spout pointing
into the sink, turn on the COLD
water faucet and divert the water
through the filter by turning the
diverter valve's "butterfly" handle
90°. Check for leaks. To stop the
flow through the filter, turn off
the faucet or turn the "butterfly"
handle in the opposite direction.
(Figure 4)
Figure 4
water ON
water OFF
7. Run COLD water through the
filter for 10 minutes, do not use
the filter or 24 hours, and then
run COLD water through the filter
for another 10 minutes. This will
remove any impurities from the
manufacturing process and expel
excess air.
NOTE: For best results, after sitting
overnight or after several hours of
non-use, run water through the filter
for 15 seconds before using. If the
filter sits for more than 48 hours of
non-use, run water through filter for 5
minutes before using.
Your Rena Ware
Aqua 3 3000 LED Ceramic
Water Filter is ready
for you to enjoy!

MAINTENANCE

The Flow Meter

Your Aqua 3 3000 LED features a
visual flow meter integrated into the
base of the unit. (Figure 5) When
water is flowing through your filter,
one of the LED (light emitting diode)
lights will flash to indicate the
following:
Figure 5
• "Filtering": This light gives off two
color indicators (alternating green
and blue) indicating the two stages
of filtration are functioning normally.
• "Reorder": The yellow warning
light lets you know approximately
300 gallons of life is left in the
CMF Cartridge. Contact your Rena
Ware Consultant or Rena Ware
Customer Service Center to order a
replacement.
• "Replace": The red warning light
indicates the filter's effectiveness
has most likely ended. Replace the
CMF Cartridge before continuing to
use your filter.
6
light emitting diodes