How To Charge The Batteries - Clarke FUSION 20I Libro De Instrucciones

Figure 16
Figure 17
Figure 18
Page -28-
HOW TO PREPARE THE MACHINE
FOR OPERATION

How To Charge The Batteries

WARNING: Charging the batteries in an area
without adequate ventilation
could result in an explosion. To
prevent an explosion, charge the
batteries only in an area with
good ventilation.
WARNING: Lead acid batteries generate
gases which could explode.
Keep sparks and flames away
from batteries. NO SMOKING!
WARNING: Failure to disconnect the AC plug
from the wall receptacle before
connecting or disconnecting the
DC connector on the charger
could result in an explosion. Al-
ways disconnect the AC plug
from the wall receptacle before
connecting or disconnecting the
DC connector on the charger.
To charge the batteries, follow this procedure:
1. Put the charger on a flat surface. Make sure the
vents on the sides are at least two inches away from
walls and other objects. Make sure there are no
objects near the vents on the bottom of the charger.
2. Set the parking brake by putting it into the down
position. See figure 16. Make sure the key switch
is in the "OFF" position.
3. Disconnect the battery pack connector from the
control housing connector. See figure 17.
4. Connect the DC connector on the charger to the
battery pack connector. See figure 18.
5. Connect the charger to a properly grounded single
phase (3-wire) wall receptacle having the voltage,
frequency, and ampere capacity specified on the
nameplate of the charger.
For more instruction on the use of the charger, read the
instruction book supplied with the charger.
Clarke ® Operator's Manual -Fusion 20 Burnisher