Tabla de contenido
Publicidad
Figure 19
Figure 20
Figure 21
Page
-30-
HOW TO PREPARE THE MACHINE FOR
OPERATION
How To Install The Pads
To install or remove pad on the machine,
follow this procedure:
1. Engage the parking brake.
2. Turn key switch "Off".
3. Push down on the headlift pedal to raise the
housing to its highest position. See Figure 19.
4. Go to the front of the machine.
5. While holding the pad retainer (page 38 , item
#42) with one hand, rotate the pad and pad driver
counter clockwise to loosen the pad retainer.
See Figure 20.
6. Remove the old pad and install a new one, being
careful to center it on the pad driver.
7. Retighten the pad retainer as tight as possible.
8. Raise the back of the machine to lower the pad
housing by lifting as shown in figure 21.
Clarke
®
Operator's Manual -Fusion 20 Burnisher
Publicidad
Tabla de contenido
