Gewiss Chorus EIB GW 10 793 Manual Del Usuario página 45

It is possible to set the following parameters:
If local set point changes are enabled via ETS, the following parameters are also
displayed and editable locally:
Heating
P01 - Set Point
heat
P02 - Set Point
heat
P03 - Set Point
heat
P04 - Set Point T
heat
P05 - Control logic (displayed but dis-
heat
abled)
if the control logic = proportional
P06 - Cycle time
heat
P07 - Proportional regulation differen-
heat
tial value
P08 - Minimum percentage value to send the command
(displayed if the 1 byte command is selected via ETS)
if the control logic = 2 points
P09 - 2 point regulation diff. value
heat
if the control logic = fan coil
P10 - Speed regulation diff. value 1
heat
P11 - Speed regulation diff. value 2
heat
P12 - Speed regulation diff. value 3
heat
if the devices is set as Slave with mode settings by ETS or autonomous with remote
controls enabled
if Slave function = on or device set as Slave with Set Point settings by ETS
P14 - Set point variation interval for manual override
if Slave function = off
OPERATING INSTRUCTIONS
Operation type (heating/air conditioning)
Day of the week
Minutes
Temperature unit of measurement
FROSTPROTECT
P13 Enabling/disabling of the Slave function
P15 - Enable remote control mode settings
Hours
Air conditioning
P01 - Set Point
cond
P02 - Set Point
cond
P03 - Set Point
cond
P04 - Set Point T
cond
P05 - Control logic (displayed but dis-
cond
abled)
P06 - Cycle time
cond
P07 - Proportional regulation differen-
cond
tial value
P09 - 2 point regulation diff. value
cond
P10 - Speed regulation diff. value 1
cond
P11 - Speed regulation diff. value 2
cond
P12 - Speed regulation diff. value 3
cond
45
HIGH TEMPERATURE PROTECTION
E
N
G
L
I
S
H