Bags And Rolls; Opening A Sealed Bag; Storage; Maintenance - CASO DESIGN FastVac 4004 Manual Del Usaurio

2. Clean and smooth the open end of the bag and be sure that there are no folds or
waves on the surfaces of the open ends.
3. Be sure that the open end of the bag is within the vacuum chamber seal. This
guarantees that there is no escape of the vacuum.
4. Close the lid and press down firmly on the front handle.
5. Press the button "Pulse vacuum". As long as you press the button, air is withdrawn.
Only when you release the button, the process stops. Thus you can exactly control
the vacuum and prevent the liquid from being sucked. Please hold the button
pressed until the required vacuum has been reached.
6. Then press the button "Seal" and seal the bag.
** Press the button "Cancel" to interrupt the process.

18.9 Bags and rolls

Please only use specified bags and rolls designed for vacuum sealing. Do not use other
materials such as plastic wrap. All vacuum rolls and bags delivered by CASO are
appropriate for cooking under vacuum (sous vide). Furthermore the vacuum rolls and bags
can be used for defrosting and heating in the microwave at up to 70° C.
Please make sure when vacuum rolls and bags of other producers are used, whether they
are also microwaveable and suitable for cooking under vacuum.
Please note that a bar vacuumsealer as this device can only be used with structured bags.
You can buy a wide range of different bags and rolls from CASO.

18.10 Opening a sealed bag

Cut the bag straight across with scissors or the cutter, just inside the seal.

18.11 Storage

Store the unit in its upright position, out of the reach of children.
► Always unplug the appliance from its outlet immediately after using and before cleaning.
► For the correct storage, please slightly close the cover, do not lock, it will deform the
gaskets and affect the machine
function.

19 Maintenance

Exchange upper/lower gasket
Turn off the device using the main
switch. Let the device cool down
completely.
Open lid of the device. Take the upper/lower gasket out of the trough in the cover of
device/from the trough around vacuum chamber. Insert the new gasket and push it with
your fingers into the trough.
PLEASE NOTE
45