Troubleshooting Guide - Campbell Hausfeld TL0539 Manual De Instrucciones

TROUBLESHOOTING GUIDE

SYMPTOM
Tool runs slowly or
will not operate
Moisture blowing out
of tool
Tool will not pull rivet
mandrel
POSSIBLE CAUSE(S)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
1. Water in tank
2. Water in the air lines/ hoses
1. Low hydraulic oil
2. Worn jaws
3. Jaws out of adjustment
CORRECTIVE ACTION
1. Flush the tool with Campbell
Hausfeld air tool oil, gum solvent,
or an equal mixture of SAE 10
motor oil and kerosene. If Campbell
Hausfeld oil is not used, lubricate
the tool after cleaning.
2. Lubricate the tool according to
the lubrication instructions in this
manual.
3. Adjust the compressor regulator to
tool maximum while tool is running
free.
4. Tighten and seal hose fi ttings if
leaks are found.
5. Be sure air hose is properly sized.
Long hoses or tools using large
volumes of air may require a hose
with an I.D. of 1/2 inch or larger
depending on total hose length.
1. Drain tank (See air compressor
manual). Oil tool and run until no
water is evident. Oil tool again and
trigger gun.
2. a. Install a water separator/fi lter
(PA2121).
NOTE: Separators work properly
only when air steam is cool.
Locate separator/fi lter as far as
possible from compressor.
2. b. Install an air dryer.
2. c. If the original separator will not
separate all the water from the
air, install a Campbell Hausfeld
belt air fi lter (PA2121).
1. Add hydraulic oil (See Maintenance
Section in manual).
2. Replace jaws.
3. Adjust jaws to fi t correctly with rivet
shank (See Operation Section in
manual).
8