Black and Decker KA293 Serie Manual Del Usuario página 10

E N G L I S H
Place the sanding belt (12) over the front
x
pulley (13) and the rear pulley (14), sliding it
through the slot in the housing.
Move the belt tensioning lever (5) to the rear
x
position (B).
Adjust the belt tracking as described below.
x
Removing
Move the belt tensioning lever (5) to the front
x
position (A).
Slide the sanding belt (12) off the pulleys.
x
Adjusting the sanding belt tracking (fig. D)
Switch the tool on.
x
Turn the belt tracking knob (6) as required until
x
the sanding belt runs straight along the length
of the arm.
Fitting and removing the dustbag (fig. E)
Make sure to remove the dustbag before
using the tool on metal workpieces.
Fitting
Align the dustbag (8) with the tool as shown.
x
Slide the dustbag onto the tool until it clicks
x
into place.
Removing
Pull the dustbag (8) to the rear and off the tool.
x
USE
Let the tool work at its own pace.
Do not overload.
Variable speed control (fig. F)
The variable speed control allows you to adapt the
speed of the tool to the workpiece material. Use a
low speed setting when using a fine grit, when
working with plastics or ceramics and when
removing painted or varnished surfaces. Use a
high speed setting when using a coarse grit and
when removing a lot of material.
Set the control knob (7) to the desired setting.
x
10
Switching on and off (fig. G)
To switch the tool on, press the on/off switch (1).
x
To switch the tool off, release the on/off switch.
x
For continuous operation:
x
- Press the on/off switch (1).
- Press the lock-on button (2).
- Release the on/off switch.
To switch the tool off when in continuous
x
operation, press and release on/off switch (1).
Emptying the dustbag (fig. E)
The dustbag should be emptied every 10 minutes
of use.
Pull the dustbag (8) to the rear and off the tool.
x
Hold the spout down and shake the dustbag
x
to empty the contents.
Refit the dustbag onto the tool.
x
If necessary, the dustbag can be removed from its
frame and washed. Let it dry before refitting it.
Special applications
Cranked arm (fig. H)
Use section A for grooving or sanding in the
x
centre of workpieces and in confined areas.
Use section B for curved surfaces.
Straight arm (fig. I)
Use the normal or narrow arm for general use,
x
for slotting and for making joints.
Narrow arm (fig. J)
Use the narrow arm for finer detail, for cutting
x
and for carving.
Hints for optimum use
Always hold the tool with both hands.
x
Do not exert too much pressure on the tool.
x
Regularly check the condition of the sanding
x
belt. Replace when necessary.
Always sand with the grain of the wood.
x
When sanding new layers of paint before
x
applying another layer, use extra fine grit.
On very uneven surfaces, or when removing
x
layers of paint, start with a coarse grit.