Using The Receiver; Switching The Receiver On/Off; Connecting The Headphones/Adjusting The Volume; Activating/Deactivating The Lock Mode - Sennheiser EM500 G2 Manual Del Usuario

Using the receiver

Switching the receiver on/off

The receiver can only be switched off when the standard display is shown on
the display panel. When in the operating menu, briefly pressing the
button will cancel your entry (ESC function) and return you to the standard
display with the last stored settings.
Press the ON button
To switch the receiver off, press the
display.

Connecting the headphones/adjusting the volume

To monitor the audio signal, connect headphones with a ¼" (6.3 mm) jack
plug to the headphone output (PHONES)
Attention! High volume!
Even short exposure to high volume levels will damage your hearing!
Set the volume for the connected headphones to the minimum before
putting the headphones on.
First, set the volume control
left as far as possible. Then gradually turn up the volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.

Activating/deactivating the lock mode

The receiver has a lock mode that can be activated or deactivated via the
operating menu (see "Activating/deactivating the lock mode" on page 24).
The lock mode prevents that the receiver is accidentally programmed or
switched off during operation.
to switch the receiver on.
ON button until "OFF" appears on the
.
to the lowest volume by turning it to the
ON
13