Adjustment Tips For The Operating Menu; Switching Between Channel Banks; Switching Between The Channels In A Channel Bank; Selecting The Frequencies To Be Stored In The Channel Bank "U - Sennheiser EM500 G2 Manual Del Usuario

Adjustment tips for the operating menu

Switching between channel banks

Bank
Via the "Bank" menu, you can switch between the receiver's nine channel
banks. The channel banks "1" to "8" have up to 20 switchable channels that
are factory-preset to a receiving frequency (see "The channel bank system"
on page 4). The channel bank "U" (user bank) has up to 20 switchable
channels to store your selection out of 1440 receiving frequencies that are
freely selectable within the preset frequency range.
When switching from one channel bank to another, the channel with the
lowest channel number is automatically displayed. If, during the last scan of
this channel bank, an interfering frequency was detected on the channel with
the lowest channel number, the receiver display panel automatically displays
the next free channel.

Switching between the channels in a channel bank

Channel
Via the "Channel" menu, you can switch between the different channels in a
channel bank. When switching between the channels, please observe the
following:
Selecting the frequencies to be stored
in the channel bank "U"
Tune
Via the "Tune" menu, you can select the frequencies to be stored in the
channel bank "U" (user bank).
When you have selected one of the channel banks "1" to "8" and then select
the "Tune" menu, the receiver automatically switches to channel 01 of the
channel bank "U". In this case, "U.01" briefly appears on the display.

Scanning the channel banks for free channels

Scan
Before putting one or several ew 500 G2 transmission links into operation,
you should scan the channel banks for free channels.
Always set the transmitter and the receiver of a transmission link to the
same channel.
After scanning the channel banks (see "Scanning the channel banks for
free channels" on page 19), only the free channels can be chosen on the
receiver. Set the transmitter and the receiver to one of the free channels.
Use the / rocker button to select the desired receiving frequency.
Receiving frequencies are tunable in 25-kHz steps within a switching
bandwidth of 36 MHz max. For intermodulation-free frequencies, please
refer to the enclosed frequency table.
19