Assembly - Ambiano VC04 Manual Del Usuario

Assembly

CAUTION!
Risk of injury and damage!
Improper handling of the multi-slicer may damage it and cause
injury.
− Make sure the multi-slicer is placed on a stable, flat surface.
− Do not connect the multi-slicer to a socket during
assembly.
− The interchangeable cutters contain sharp edges. Be very
careful when assembling the multi-slicer.
1. Place the axis of the filling tube
Secure the filling tube by turning it to the left (see Fig. B).
2. Select a suitable interchangeable cutter
(see chapter "Overview of the interchangeable cutters").
3. If an interchangeable cutter has already been assembled in the filling tube,
rotate the fastener
filling tube (see step 1 in Fig. C).
4. Remove the interchangeable cutter from the filling tube.
5. Insert the selected interchangeable cutter into the filling tube
(see step 2 in Fig. C).
Make sure the interchangeable cutter is positioned correctly.
6. Place the fastener in the filling tube and then rotate the fastener to the left
to secure it (see step 3 in Fig. C).
7. Place the presser
The multi-slicer is now ready for use (see Fig. D).
To remove the filling tube from the main unit, rotate it to the
right and then detach it from the main unit.
To remove the interchangeable cutter, follow steps 3–4.
To replace the interchangeable cutter, follow steps 3–6.
AFTER SALES SUPPORT
866-235-5029
USA
2
6 to the right and then remove the fastener from the
into the filling tube.
1
into the opening of the main unit
/ /
7 8 9
info@customercareusa.com
Assembly
/ /
10 11
USA
4 .
15