Programming The Timer - Fulgor Milano LIFELINE FSH 905 ID TS Manual De Instrucciones

even when the On/Off button is pressed

Programming the timer

for the cooking areas
GB
By turning on the touch display, you can
program an independent timer for each
cooking area.
- At least one cooking area must be on and
set to a certain level.
- By pressing the + and - buttons
simultaneously, you can set a countdown
for turning off the cooking area. There are
illuminated clock icons (13) next to the
display of the cooking area. To set the
timer on a cooking area when there are
more than one cooking area on, you must
press the + and - buttons simultaneously.
You will note that the clock icon will light
and move to the various cooking areas
each time you simultaneously press the +
and - buttons.
- When the timer of the cooking area is
selected, the related clock icon near the
Error codes are displayed by the 7-segment display with "E" or "ER" plus the error number.
Error
message
"flash"
Er 22
Er20
Description
Permanent use of
keys; Control unit
cuts off after 10
sec
Defective Key
evaluation .
Control unit cuts
off after 3.5 –
7.5 sec.
Flash-failure
display becomes brighter (13). The timers
programmed for each cooking zone
remain active.
- Other functions of the timer are the same
as the independent timer. To increase the
time, use the plus button.
- The expiry of the time is signalled by a
beep and "00" on the display and the LED
of the cooking area assigned to the timer
flashes. The cooking area is turned off
and an "H" is shown if the area is "hot",
otherwise the display shows a hyphen.
The beeping and flashing of the display
stop.
- Automatically after 2 minutes.
- When you press the + or - buttons, the
timer display turns off.
Possible error
reason
Water or cooking
utensils on the
glass above the
control unit
Short-circuit or
discontinuation
in the range of
the key
evaluation
µC- faulty
28
Troubleshooting
Cleaning of the
operational
surface
Exchange control
unit
Exchange control
unit