Instruction For Use - Ca-Mi NEW HOSPIVAC 400 Manual De Instrucciones

GB
BEFORE EVERY CHECKING OPERATION, IN CASE OF ANOMALIES OR BAD FUNCTIONING, PLEASE CONTACT CA-MI
TECHNICAL SERVICE. THE MANUTACTURER DOES NOT GIVE GUARANTEE IF INSTRUMENT, AFTER THE
TECHNICAL SERVICE CHECKING, APPEARS TO BE TAMPERED.

The working position must be such as to allow one to reach the control panel and to have a good view of the empty indicator, the
jar and the antibacterial filter.

If the device is to be transported from one place to another, to prevent the liquid collection jar from falling and consequently the
liquid from spilling, removing the jar from the device is recommended.
WARNING: For proper use, place the aspirator on a flat, stable surface in order to have the full volume of use of the jar and
better efficiency of the overflow device. The vacuum jar, during use, must be used in vertical mode, to prevent the action of the
backflow valve. If this protection is triggered, turn the device off and disconnect the pipe connected to the vacuum jar (indicated with
the word VACUUM) on its cover.

Place the unit on a flat, horizontal surface
 Connect one end of the short silicon tube, with antibacterial filter, to the suction connector on the lid of the jar.

The other tube already connected to the filter has to be connected to the "VACUUM" jar outlet, where has been fixed the red float
(security float). When the 90% of the volume of the jar is reached there is the activation of the security float (the float close the
aspiration connector on the jar) to avoid liquid penetration inside the device.
WARNING: Ensure that the FLUID SIDE or IN marker on the filter is on the side facing the collection jar lid and fitted into the
"VACUUM". A wrong connection causes immediate destruction in case of contact with sucked liquids
WARNING: Ensure that the IN marker on the filter is on the side facing the collection jar lid and fitted into the "VACUUM".
A wrong connection causes immediate destruction in case of contact with sucked liquids.
assembling
Filter
Suction Pump
Inlet

Connect the long silicon tube with the lid union still free and marked as "PATIENT".

Connect the conical junction for probe insertion with the free end of the long silicon tube.
 Insert the plug of the equipment feeding cable into a power socket.

Press the ON/OFF button to start the medical equipment.

To deal with foam formation within the tank, unscrew the tank lid and fill 1/3 of the tank with water (to make cleaning easier
and speed up depression while operating the equipment), place the lid on the jar.

While using the equipment, the suction tank should always be used vertically to avoid the intervention of the antireflux valve. In
case of intervention of this protection, switch the device off and disconnect the tube connected with the suction tank (the one
marked as "VACUUM") on the same lid.

You can then detach all accessories and perform cleaning operations as described under "Cleaning accessories and internal
parts" below.
WARNING: The power supply cable plug is the element of separation from the electrical mains system: even if the units equipped
with a special on / off switch button, the power supply plug must be kept accessible once the device is in use so as to allow a further
method of disconnection from the mains supply system.
MAKE SURE THAT CHILDREN AND/OR MENTALLY ILL PEOPLE DO NOT USE THE DEVICE WITHOUT ADULT
INSTRUCTIONS
FLOW DIRECTION
IN
NEVER USE THE DEVICE WITHOUT JAR AND / OR PROTECTION FILTER
ALWAYS PLACE THE DEVICE IN POSITIONS FOR EASY DISCONNECTION.
IN / Fluid Inside
Jar Air Tube
SURVEILLANCE
20