User Interface - Hach 2100N IS Manual Básico Del Usuario

User interface

Figure 4 Keypad
1 ENTER key
2 EDIT (arrow) keys
3 RANGE key
4 UNITS/Exit key
Table 1 Key descriptions
Key Description
Enters the value on the display. Starts the measurement of a
calibration standard. Clears data from the buffer.
Changes the numbers and/or letters on the display. Steps through
the calibration standards. The right arrow key moves the cursor to
the previous or next digit.
Selects automatic or manual ranging.
Selects the unit of measure. Exits Calibration or Setup mode
without saving changes.
5 UNITS AVG key key
6 SETUP key
7 PRINT key
8 CAL key
Table 1 Key descriptions (continued)
Key Description
Turns signal averaging on or off.
Turns on Setup mode and starts the selection of the setup number.
Sends the data that is on the display to a printer or computer.
Sends a calibration data report to a printer or computer when in
Calibration mode. Sends diagnostic results to a printer or computer
if held down when the instrument is turned on. Provides a print of
the setup commands when in Setup mode.
Starts or completes a calibration.
English 7