Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Table of contents
Specifications
Specifications are subject to change without notice.
Specification
Details
Measurement method
Nephelometric
Regulatory
Meets ISO 7027, DIN EN 27027, DIN 38404 and
NFT 9033
ASTM D7315 - Standard Test Method for
Determination of Turbidity Above 1 Turbidity Unit
(TU) in Static Mode
ASTM D6655 - Standard Test Method for
Determination of Turbidity Below 5 NTU in Static
Mode
Light source
Light-emitting diode (LED) at 860 ± 30 nm
Measurement modes
FNU and NTU
FNU (manual range): 0-0.999, 0-9.99, 0-99.9,
0-1000
FNU (auto range): 0-1000
NTU (manual range): 0-0.999, 0-9.99, 0-99.9,
0-1000
NTU (auto range): 0-1000
1, 2
Accuracy
±2% of reading plus 0.01 FNU/NTU from
0-1000 FNU/NTU
1
Turbidity specifications identified using recently prepared formazin standard and matched 1-inch sample cells.
2
Intermittent electromagnetic radiation of 3 volts/meter or greater may cause slight accuracy shifts.
Specification
Details
Resolution
Turbidity: 0.001 FNU/NTU (on lowest range)
Repeatability
±1% of reading or 0.01 FNU, whichever is greater
(under reference conditions)
Response time
Signal averaging off: 6.8 seconds
Signal averaging on: 14 seconds (when
10 measurements are used to calculate the average)
Stabilization time
Immediately
Reading modes
Manual or auto range, signal averaging on or off
Power requirement
115-230 VAC, 50/60 Hz (automatic power selection)
28 W maximum
Pollution
2; II
degree/installation
category
1
Operating conditions
Temperature: 0 to 40 °C (32 to 104 °F)
Relative humidity: 0-90% at 25 °C, 0-75% at 40 °C,
noncondensing
Altitude: 2000 m (6560 ft) maximum
Indoor use only
Storage conditions
-40 to 60 °C (-40 to 140 °F), instrument only
Interface
RS232C serial interface by way of DB9 subminiature
D-shell connector for data output to computer or
printer, and data input (command). No handshaking.
English 3
Publicidad
Tabla de contenido
Solución de problemas
