Code Retrieval; Channel Lock - One for All OARN03S Guia Del Usuario

Channel Lock

Channel lock automatically sends channel commands, like the
CH, LAST, and 0–9 number keys, to your satellite receiver, cable
box, or digital TV converter when you're in TV mode. This can
save you keypresses if you use a device other than your TV to
change channels.
To turn channel lock on:
1.
Press and hold the device key for the device you use to
change channels. While you're holding down this device
key, use your other hand to press and hold the remote's CH
up key at the same time.
2.
Wait until the remote's POWER key comes on and stays on.
Then release both keys.
3.
Press ENTER to lock channel commands to this device.
To turn channel lock off:
1.
Press and hold the TV key. While you're holding down the
TV key, use your other hand to press and hold the remote's
CH down key at the same time.
2.
Wait until the remote's POWER key comes on and stays on.
Then release both keys.
3.
Press ENTER to start changing channels with your TV.

Code Retrieval

Once you've programmed the remote to control your devices,
you may want to record the codes for future reference. If
you used the Direct Code Entry method, this is easy. Just find
the codes you entered and make a note of them in the boxes
below. If you used one of the Code Search methods to program
your remote or if you used the Direct Entry method but don't
remember the code, you will need to retrieve each device's five-
digit code. Retrieving the actual code and writing it down will
save you time if you ever need to program the remote again. If
the codes are recorded, you can use the Direct Entry method to
reprogram your remote to control your devices, which is quick
and easy.
1.
Press and hold the device key (TV, SAT•CBL•DTC, DVD•VCR)
whose code you wish to retrieve. The POWER key
illuminates. Keep pressing the device key.
2.
While holding the device key down, press and hold the
INFO key. The POWER key turns off. After holding down
both keys for three seconds, the POWER key turns back on.
3.
Release both keys. The POWER key remains on.
4.
Starting with the number 1 key, press and release each
number key on the keypad in the following order: 1-9, then
0. The number that causes the POWER key to blink is the
first number of the code. As you find each number of the
code, write it down for future reference.
Note: All TV codes begin with the number 1; all VCR
and DVR codes begin with the number 2; all DVDs, the
number 3; and all satellite receivers, cable boxes and DTV
converters, the number 5.
5.
Repeat step 4 until you have retrieved all five numbers in
the code. After the fifth number is retrieved, the POWER
key blinks briefly, then turns off.
TIP: To exit the Code Retrieval Mode at any time, press the
EXIT key.
10