Advanced Functions; Reassigning The Dvd•Vcr Key To Control A Vcr; Volume Punch-Through; Transport Key Punch-Through - One for All OARN03S Guia Del Usuario

Advanced Functions

Reassigning the DVD•VCR Key to
Control a VCR
The DVD•VCR key defaults to control a DVD player. If you want
the DVD•VCR key to control a VCR, you must reassign it.
1.
Press and hold the DVD•VCR key. The POWER key
illuminates. Keep holding down the DVD•VCR key.
2.
While holding down the DVD•VCR key, press and release
the number 2 key on the keypad. The POWER key turns off.
3.
Release the DVD•VCR key. The POWER key blinks four times
and then turns off. The DVD•VCR key is now set to control
a VCR.
4.
Follow the directions in the auto, brand, direct entry, or
manual code search to program the DVD•VCR key for your
VCR.

Volume Punch-Through

Volume punch-through allows the VOL and MUTE keys, when
pressed in SAT•CBL•DTC or DVD•VCR modes, to "punch
through" to TV. Volume punch-through occurs automatically
and allows you to control the volume without exiting the
current mode.
Note: Volume punch-through does not occur in cases where
the component code has its own volume/mute controls, such as
some satellite receivers.

Transport Key Punch-Through

Transport key punch-through allows the transport keys
(REVERSE, PLAY, FORWARD, RECORD, STOP, PAUSE, SKIP BACK,
SLOW, and SKIP FWD), when pressed in TV or SAT•CBL•DTC
modes, to "punch through" to DVD•VCR mode. Transport key
punch-through occurs automatically and allows you to use the
transport keys without exiting the current mode. For example,
if the transport keys were last used in DVD mode and accessed
again after pressing the TV key, they will punch through to the
DVD.
Note: Transport key punch-through does not occur in cases
where the device code has its own transport key data, such as a
satellite receiver with a built-in DVR.
9