Testing The Code For Maximum Functionality; Brand Code Search - One for All OARN03S Guia Del Usuario

During the Auto Code Search, the remote ignores keypresses
that aren't part of the search.
The search times out after two minutes (the POWER key blinks
four times and turns off, and the last programmed code under
that device key is retained).
The POWER key blinks four times and turns off when the
remote has gone through all the codes. The remote exits the
Auto Code Search. If your device hasn't turned off yet, try a
different search method.

Testing the Code for Maximum Functionality

1.
Try a variety of the device's functions with the remote. If
some device features don't work, go to the next step to try
a different code.
2.
Repeat the Auto Code Search Method from the beginning.
When your device turns off, do not stop searching. Instead,
with the unit now off, continue to press the PLAY key every
5 seconds until the unit turns back on.
3.
Once the unit turns back on, press the REVERSE key on the
remote every 2 seconds until your device turns off again.
When your device turns off again, press the STOP key.
4.
Test the key's functionality again by attempting to control
a variety of the device's functions. If the code that has
been stored controls the majority of the device's functions,
programming is complete. If the code stored does not give
maximum functionality, try another code.

Brand Code Search

The Brand Code Search goes through only the codes for one of
the select brands listed in the accompanying code list. If your
brand of device is listed, this search can be very quick and easy.
TIPS: Each device key is associated with a type of device—the
TV is preset to search for TVs, SAT•CBL•DTC for satellite
receivers, cable boxes or digital TV converters, and DVD•VCR
for DVD players. To program the DVD•VCR key to control a PVR
or VCR, see the Reassigning the DVD•VCR Key to Control a VCR
section.
To exit without saving a new code at any point in the Brand
Code Search, press the EXIT key.
1.
Manually turn on the device you want to control.
2.
Find your device's brand in the Brand Code list section of
the accompanying code list. Circle the number for your
brand and keep the list handy.
3.
Press and hold the device key you want to program. The
POWER key illuminates.
While you're holding down the device key, use your other
hand to press and hold the remote's POWER key at the
same time. The POWER key turns off.
4.
Wait until the POWER key comes on and stays on. Then
release both keys.
5.
Look at the numbers you circled for your device's brand
code number. Press those numbers on the remote keypad.
Note: For single-digit brand codes, press the 0 key first (for
example, 0-5 for 5).
4