U.S.Robotics USR5411 Guia De Instalacion página 10

Step Two: Connect to a Wireless Network
A. When you are prompted, select Connect to an established wireless router and click Next.
You will need to wait while the Wireless MAXg PC Card communicates with the router.
B. A list of available wireless networks will appear on the "Connect to Existing Router or Access
Point" screen.
C. Select the appropriate wireless network and click Next.
Note: If the device does not appear in the list, you can enter the name of the network
under Network name. One reason the device may not appear is if Broadcast Network
name is disabled in your wireless router or access point. You can also click Detect and
your Wireless MAXg PC Card will search the area again for available wireless networking
devices.
D. Configuration information for that network will appear. If the network specified is not secure,
the "Installation Complete" screen will appear. Click Finish. If you have specific security settings
enabled on the wireless network you will be connecting to, such as WEP or WPA2, you will need to
select your security type and click Next. Enter the appropriate security information on the next
screen and click Next.
E. Click Finish. If prompted when the setup is complete, restart your computer.
Congratulations!
should be connected to the wireless network that you selected.
If you experience any problems connecting to a wireless networking device, refer to the
Troubleshooting section in this guide or to the Configuration section of the User Guide on the
U.S. Robotics Installation CD-ROM for more information.
6
You have finished installing your product! The Wireless MAXg PC Card