USE AND CARE
Cooking
Always turn the downdraft blower on before you begin cooking
to establish an air flow in the kitchen. Let the blower run for a few
minutes to clean the air after you turn the cooktop off. This will
keep the whole kitchen cleaner and brighter.
It is recommended to use the rear burners when cooking with tall
pots or when the cooking method will generate high amounts of
smoke or steam. The combination of using the rear burners and
operating the unit at high speed will increase the likelihood that
all the smoke and steam will be removed by the downdraft.
WARNING: Always disconnect electric power
supply before cleaning and/or servicing unit.
Cleaning
EARS
FILTER
FILTER
BAFFLE
To clean grease filters:
Lift FRONT PANEL and BAFFLES up and out and take out the
GREASE FILTERS. Wash filters in a mild detergent solution or
a dishwasher. Replace filters, baffles and front panel and before
using downdraft. Be sure to engage TABS on front panel behind
EARS as shown.
!
CAUTION: Failure to engage tabs properly may cause
chimney to jam and fail to raise up.
To clean inside chimney:
Lift FRONT PANEL and BAFFLES up and out and take out
the GREASE FILTERS. Use a mild detergent. DO NOT USE
ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING
POWDERS. Replace filters, baffles and front panel and before
using downdraft. Be sure to engage TABS on front panel behind
EARS as shown.
!
CAUTION: Failure to engage tabs properly may cause
chimney to jam and fail to raise up.
Models D49M30SB • D49M36SB • D49M48SB
TABS
BAFFLE
FRONT
PANEL
Servicing
It may be necessary to remove the downdraft blower system from
the cabinet in order to service components such as the blower
motor or air vent mechanism.
Disconnect power to the cooktop and remove it first. Reverse the
steps under "INSTALL HOUSING INTO CABINET" to remove the
downdraft from the cabinet.
Page 11