Best D49M30SB Manual Del Usuario página 6

INSTALL HOUSING INTO
CABINET
1. Remove cooktop.
UP
BUTTON
CABLE
RECEPTACLE
2. Plug UP BUTTON CABLE from right trim into UPPER
RECEPTACLE at bottom right side of downdraft housing and
connect ground wire to GROUND NUT. Run cable up along side
of housing and TAPE in place near top.
3. Set housing into cabinet / countertop opening as far back as
possible. Make sure up button cable threads through opening
as shown and is not pinched.
4. Make sure housing is level.
TAPE
GROUND
NUT
UPPER
Models D49M30SB • D49M36SB • D49M48SB
(2) #10 X .500 WOOD SCREWS
5. Extend SUPPORT LEGS and attach to bottom of cabinet with
(2) SCREWS through each leg. Tighten HEX SCREWS.
If cabinet bottom is removed:
Use blocks as spacers between floor and support legs.
6. Extend UPPER SUPPORT BRACKETS and attached to sides
of cabinet with (2) SCREWS through each bracket.
Installations using FLEX BLOWER only:
7. Loosen (4) SCREWS attaching BLOWER SUPPORT LEGS
to FLEX BLOWER. Extend legs and secure them to bottom of
cabinet with a SCREW through each bracket.
SUPPORT LEG
UPPER
SUPPORT
BRACKET
(2)
#10 X .500
WOOD
SCREWS
FLEX
BLOWER
(4) 1/4-20
X .500
SCREWS
SCREWS
Page 6
HEX
SCREW