Main Technical Characteristics; Parameter Settings - fluidra 65542 PROHEAT II 35KW Manual Técnico, Arranque Y Funcionamiento

PROHEAT II SERIES · AIR/WATER SYSTEM
manual interlock and reset that cuts off the general power to the machine if pressed.
• MINIMUM VOLTAGE STOP: The machine is protected against severe voltage drops in
the line by an automatic cut-off device in the main circuit breaker; this device triggers
when voltage drops to a certain level below the nominal voltage.
6.2.

MAIN TECHNICAL CHARACTERISTICS.

•
Power supply: 230V±10% or AC 380V±10% (See circuit diagram)
• Maximum output capacity:
o Water pump
to a contactor is recommended)
o Fan:
o Compressor 1
o Compressor 2:
o 4-way valve:
•
Temperature probes: NTC R25=5kΩ,B(25/50)=3470K
6.3.

PARAMETER SETTINGS

Press "S" for 5 seconds to enter the parameter settings menu. If a password has been
programmed (F80), keys "" can be used to enter the password. Once the password is
entered correctly, the display will show the parameter code. Use "" to select the code,
press "S" to show the parameter setting and use "" to change it, if necessary. Press "S"
again to save the changes and return to the parameter settings menu. Press "M" to exit the
parameter settings menu at any time without saving the changes.
Concept Code Parameter name
F11 Temperature setpoint
F12 Temperature differential
Maximum setpoint
F13
temperature
Temperature
Minimum setpoint
F14
temperature
Automatic mode
F17
temperature differential
F21 Compressor delay time.
Compressor
Compressor phase
F22
protection
© FLUIDRA 2016 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
30A/220VAC (Connecting the water treatment pump
10A/220VAC
5A/220VAC
5A/220VAC
5A/220VAC
Factory
Range
setting
F14-F13 28
1 - 10 1
30–100 40
0–29 10
0 - 20 1
1 – 10 5
0-1 0
ENGLISH
Unit Observations
Range limits between
°C
F13 and F14
°C Water input
°C Water input
°C Water input
°C
min
0: Enabled
1: Not Enabled
Pag: 18