Storage & Service; Specifications - Tripp-Lite SMARTINT2200VS El Manual Del Propietario

Ocultar thumbs

página de 44

/ 44
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

200404080 932245 SMARTINT22003000VS OM.qxd

Storage & Service

Storage

Before storing your UPS, turn it completely OFF: with the UPS ON and receiving utility power,

press and hold the ON/OFF/STANDBY button for one second (an alarm will beep once briefly

after the interval has passed); then, unplug the UPS from the wall outlet. If you store your UPS

for an extended period of time, recharge the UPS batteries once every three months: plug the

UPS into a wall outlet; allow it to charge for up to 4 hours; and then unplug it and place it back

in storage. Note: after you plug the UPS in, it will automatically begin charging its batteries;

however, it will not supply power to its outlets (see Quick Installation section). If you leave your UPS

batteries discharged for an extended period of time, they will suffer a permanent loss of capacity.

Service

Before returning your UPS for service, follow these steps:

1. Review the installation and operation instructions in this manual to ensure that the service

problem does not originate from a misreading of the instructions. Also, check that the UPS

System's circuit breaker(s) are not tripped. This is the most common cause of service

inquiries which can be easily remedied by following the resetting instructions in this manual.

2. If the problem continues, do not contact or return the UPS to the dealer. Instead, call Tripp Lite

at (773) 869-1233. A service technician will ask for the UPS's model number, serial number

and purchase date and will attempt to correct the problem over the phone.

3. If the problem requires service, the technician will issue you a Returned Material

Authorization (RMA) number, which is required for service. If you require packaging, the

technician can arrange to send you proper packaging. Securely pack the UPS to avoid damage

during shipping. Do not use Styrofoam beads for packaging. Any damages (direct, indirect,

special, incidental or consequential) to the UPS incurred during shipment to Tripp Lite or an

authorized Tripp Lite service center is not covered under warranty. UPS Systems shipped to

Tripp Lite or an authorized Tripp Lite service center must have transportation charges prepaid.

Mark the RMA number on the outside of the package. If the UPS System is within the 2-year

warranty period, enclose a copy of your sales receipt. Return the UPS for service using an

insured carrier to the address given to you by the Tripp Lite service technician.

Specifications

Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.

Model:

Series #:

Input

Nominal Voltage/Frequency:

Output

Capacity (VA/Watts):

On Line Nominal Voltage/Waveform:

On Battery Nominal Voltage/Waveform:

Battery Runtime (Half Load/Full Load) Minutes:

Battery Recharge Time:

Approvals:

ALL UNITS: Voltage-Regulated Output Voltage Range: -18% / +8%. On-Battery Output Voltage Range: ± 5 %. AC Surge Suppression (exceeds IEEE 587 Cat. A & B stan-

dards); AC Noise Attenuation (>40 dB at 1MHz); AC Protection Modes (H to N, H to G, N to G).

"+" Battery runtime can be extended with addition of optional Tripp Lite External Battery Pack (sold separately). SMARTINT3000VS uses BP48V18 battery pack. External

battery will increase both the battery runtime and the battery recharge time.

Note on Labeling

Two symbols are used on the label.

V~ : AC Voltage

: DC Voltage

5/26/2004

4:26 PM

SMARTINT2200VS

AGSM4839

230VAC 50/60 Hz

2200/1600

230VAC/sine wave