Network Settings - Tripp-Lite PDUMVR20NET El Manual Del Propietario

Installation
Static IP Address Assignment
4-5
Configure PDU in Terminal Mode: After a brief pause, an initialization page should
appear in the terminal emulation program. Press any key on the keyboard within 5 seconds
to change the PDU settings.
Note: If the 5-second period has elapsed, you can reboot the PDU by:
1. Using a small tool or paper clip to press the recessed Reset button on the PDU for 3 seconds.
2. Pressing any key during, or after, the boot process. This will prompt for a login name and password.
The default user name and password for this process are both "localadmin." After logging in, type
"reboot" to initiate the card reboot.
Press A to Accept the settings, or M to Modify? M
Enter the root password: *********
Reset configuration and root password to default values. (Y/N)? N

Network Settings

Follow the prompts to configure IPv4 and IPv6 address settings. The default terminal mode
password is TrippLite. Sample IP settings are shown—supply your own IP information when you
configure your card.
ETHERNET INTERFACE SETTINGS:
Obtain IPv4 settings automatically using DHCP for Ethernet interface? [Y]
IP address? [10.1.0.165]
Subnet mask? [255.0.0.0]
Gateway address? [10.0.0.1]
Enable DHCPv6 for the Ethernet interface? [Y]
Enable static IPv6 for the Ethernet interface? [N]
IPv6 address? [2001:DB8::1:58:4F43:4849:544C]
Network prefix length? [64]
DNS server? [10.0.0.8]
This card's host name? [poweralert-061033462177]
This card's domain? [tlsoftwaredev.local]
13-02-027-933161-revB.indb 6
6
2/7/2013 1:19:14 PM