Información Del Usuario - X-Rite ATD Manual Del Instrumento

Densitómetro de barrido automático
Tabla de contenido

Publicidad

I N T R O D U C C I Ó N
Información del Usuario
FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his
own expense.
NOTE: Shielded interface cables must be used in order to maintain compliance with
the desired FCC and European emission requirements.
Canada
This Class A digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.
AVERTISSEMENT : Des câbles d'interface blindés doivent être utilisés afin de se
conformer aux règlements européens et FCC (USA)sur l'émission
Keep Cal Plaques Clean At All Times.
Kalibrierstandard stets sauber halten!
Siempre mantenga la placa de calibración limpia.
Tenir le plaque de calibration propre tout le temps.
Sempre mantenga la placca della calibrazione pulita.
Do Not Oil Moving Parts.
Bewegliche Teile nicht ölen!
No lubrifique las peizas en movimiento
Ne pas lubrifier les pièces en mouvement
Non lubrificare le parti mobili.
i

Publicidad

Tabla de contenido
loading

Tabla de contenido