Attaching Traction Unit Stand To Table - Chattanooga Triton DTS TRT-600 Manual Del Usuario

SETup

ATTAChiNg TrACTiON uNiT STANd TO TABLE

Attach the Traction Stand Pivot
Plate to the table and fasten with
the two supplied 1/4-20 screws.
NOTE: Make sure that the holes
of the Traction Stand Pivot
Plate and the table are
aligned before securing
the Traction Stand Pivot
Plate to the table.
Attach the two supplied 1/4-20
ESNA nuts to each screw and
16
tighten with a 7/ in wrench.
Attach the Traction Unit Stand to
the aligning holes of the Traction
Stand Pivot Plate and the table.
13
®
Triton DTS TRT-600 Spine Therapy Table
Place the two supplied 13 mm flat
washers underneath the Traction
Stand Pivot Plate.
16
Attach the supplied 9/ in ESNA
16
nut and tighten with a 9/ in
wrench.
Position the adjustment knob
of the Traction Unit Stand to the
desired degree of the Traction
Stand Pivot Plate.