Napa Carlyle DTW39FL Manual Del Usuario página 12

USING ANGLE FUNCTION
Setting Angle Values
Pressing the
1.
sequentially though each of the units of measure
until you reach the angle display.
2. Use the Up arrow to increase angle value.
Use the Down arrow to decrease angle value.
Resetting Preset Angle Values
Torque Wrench comes with 9 Preset values
pre-installed at the factory.
To change a preset value stored in memory:
1. Press the memory button repeatedly to
access the preset value to be changed. (e.g. M1)
2. Press the button to navigate to the angle
mode if required.
3. Use the UP/DOWN arrow buttons to
change the angle value.
Do one of the following:
A. Press the button to store the new angle
value. The torque wrench will stay at the new
memory location and will be ready for immediate
use.
B. Press the button to go to the next memory
location in sequence. This is useful if you
are wanting to change/store multiple values.
Using Angle Mode
Angle Mode is used when it is required to rotate the fastener a specified number of degrees after a designated
torque has been applied.
Angle Mode: This mode allows the operator to visually monitor the amount of angle applied to the load.
Visual and auditory aids assist the operator in maintaining a consistent angle.
After setting the Angle mode and assigning a Memory Pre-Set value to use, the operator should start by selecting the
desired corresponding unit of measure. This operation is necessary in order to ensure that the proper unit of measure
for the related torque will be displayed after the load is applied.
DTW38FL, DTW12FL
button allows you to cycle
Increases
Angle Value
Pre-Set Memory Indicator: M1
Press or
Pre-Set Memory Indicator: M2
Press
Pre-Set Memory Indicator: M3
Pre-Set Memory Indicator: M9
12
Angle Value
Decreases
Angle Value
for immediate use.
- M4,
- M5 . . . etc.
Rev. 01/23/13