Track Mode - Napa Carlyle DTW39FL Manual Del Usuario

If this warning appears, the wrench has applied more
than 110% of the torque set in memory.
SELECTING TRACK AND PEAK MODES
At start up either (P) or (T) will show in the lower right hand
corner of the display depending on the last time the
wrench was used.
Note: Track (T) mode is the factory default.
1. In order to change the mode, press and hold the
button for 2 seconds.
2. Use the Up/Down buttons to toggle
between the Track (T) and Peak Hold (P) modes.
3. Press button six (6) times to exit mode setting.

TRACK MODE

Track Mode: This mode allows the operator to visually monitor the amount of load that is being applied.
Visual and auditory aids assist the operator in maintaining a consistent torque.
After setting the (T) Track mode and assigning a
Memory Pre-Set to use, operator can begin to apply
load to the wrench.
As a load is gradually applied to the wrench, the display
will show the operator the amount of torque on the
fastener.
When 80% of the desired torque is reached, the green
lights will begin to flash and the alarm tone will beep
intermittently.
When 99.5% of the desired torque has been reached,
the alarm will change to a steady tone, and the green
lights will stop flashing and stay on. The red light will
also illuminate.
DTW38FL, DTW12FL
Flashing green light and intermittent
tone at 80% of desired torque
((...((... ...))...)) ((...((...
Buzzer
Solid green and red light and steady
tone at 99.5% of desired torque
(((((((( ))))))))
Buzzer
9
...)) ...))
Green LED
Reach 80% of Target
Torque
((((((( )))))))
Red LED
Approached Target Torque
Rev. 01/23/13