Assembly — Installing the Light Kit
9
Installating the light kit plate
CAUTION: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing the light kit.
□
Remove the 17W LED assembly (J) from the light kit
plate (I) by removing three light kit plate screws (MM).
Set these screws (MM) aside for use later.
□
Remove one of three screws (LL) from the fan motor
assembly (H) mounting ring and loosen, but do not
remove, the other two screws (LL).
□
Place the key holes from the light kit plate (I) over the
two screws (LL) previously loosened from the fan motor
assembly (H) mounting ring. Turn the light kit plate (I)
until it locks in place at the narrow section of the key
holes. Secure by tightening the two screws (LL)
previously loosened and the one screw (LL) previously
removed.
MM
H
LL
10
□
□
□
□
I
J
I
13
Please contact 1-855-HD-HAMPTON for further assistance.
Installing the 17W LED assembly
and glass shade
While holding the 17W LED assembly (J) under your
fan, rmly snap the wire connection plugs (OO)
together.
Position the 17W LED assembly (J) on the light kit
plate (I) and ensure the screw holes are properly
aligned.
Secure the 17W LED assembly (J) by replacing the
three screws (MM) previously removed. Tighten all
screws securely.
Attach the glass shade (K) to the light kit plate (I)
by twisting tightly.
H
J
MM
K
I
OO
I
HAMPTONBAY.COM