Assembly — Hanging the Fan (continued)
3
Attaching the coupling cover, canopy
cover, and canopy to the downrod
□
Slip the coupling cover (G), canopy cover (D), and canopy
(C) onto the downrod (F). Carefully reinstall the hanger
ball (E) onto the downrod (F), and ensure that the cross
pin (FF) is in the correct position, the set screws (II) are
tight, and the wires are not twisted.
FF
E
C
D
II
F
G
8
4
Hanging the fan motor assembly
from the mounting bracket
□
Lift the fan motor assembly (H) into position, and place the
hanger ball (E) into the mounting bracket (B). Rotate the
fan motor assembly (H) until the check groove drops into
the registration slot (NN) and seats rmly. The downrod (F)
should not rotate if this is done correctly.
B
NN
E
F
H