Stopping The Motor; Adjusting The Height-Of-Cut - Toro Eurocycler 34cm Manual Del Operador

4. While holding in the button, pull the control bar
toward the handle (Figure 16).
5. Hold the control bar to the handle and release the
button (Figure 17).
Figure 15
Figure 16
Figure 17

Stopping the Motor

1. Release the control bar (Figure 18).
2. Disconnect the mower from the power source if you
leave the mower unattended.

Adjusting the Height-of-Cut

The mower has 6 height-of-cut positions (all heights are
approximate): A=20 mm; B=31 mm; C=42 mm; D=53
mm; E=64 mm; and F=75 mm.
DANGER
Adjusting the cutting height levers could bring your
hands and feet into contact with a moving blade
and result in serious injury.
Stop the motor and wait for all moving parts to stop
before changing the height-of-cut setting.
1. Stop the motor and wait for all moving parts to stop.
2. Press down on the height-of-cut adjustment button
with your thumb and push down or lift up the
height-of-cut handle to the desired cutting height
setting shown on the height-of-cut level reading
(Figure 19).
8
Figure 18