Outdoor Unit (Doorbell); Installation; Placing The Indoor Unit (Monitor); Mount The Outdoor Unit (Doorbell) - Byron DIC-22815 Manual De Usuario

2. Power on/off
3. Power indicator
4. Charge indicator
5. Interface buttons
6. Microphone
7. AC adapter

2.2.2 Outdoor unit (doorbell)

1. Microphone
2. Night sensor
3. Outdoor camera
4. Call button
5. External antenna connection (On the back of the unit)
6. Reset button (On the back of the unit)
3

Installation

3.1 PLACING THE INDOOR UNIT
(MONITOR)
The indoor unit (monitor) is designed to stand on a table or any flat
surface.
A. Pull out the stand leg on the back of the indoor unit.
B. Pull the antenna on the back of the indoor unit to an upright
position.
C. Place on any flat surface.
3.2 MOUNT THE OUTDOOR UNIT
(DOORBELL)
To mount the outdoor unit, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Use a knife or sharp object to puncture the cable gland. (Optional,
only when installing the AC Power. Cables are not included.)
F. Pull the required cables through the cable gland. (Optional, only
when installing the AC Power. Cables are not included.)
G. Fasten the mounting plate with the screws.
H. Remove the front cover of the outdoor unit by removing the screw
at the bottom.
I. Attach the outdoor unit to the mounting plate.
J. Fasten the outdoor unit with the supplied screws.
K. Charge the battery (see 3.3.3) and place the battery in the
outdoor unit.
L. Place the front cover and fasten the screw at the bottom of the
outdoor unit to secure the cover.
3.3

ELECTRICAL INSTALLATION

Instruction manual
EN
7