Connecting Ac Power To The Indoor Unit (Monitor); Installing And Charging The Indoor Unit Battery; 3.3.3 Charging Outdoor Unit Battery; Installing A Microsd Card (Not Included) - Byron DIC-22815 Manual De Usuario

Instruction manual
3.3.1 Connecting AC power to the indoor unit
(monitor)
The monitor is portable and can be used on battery power, AC power
or both. When the AC adapter is connected the battery charges until
full and then operates directly from the AC adapter. The AC adapter
used is a standard micro USB charger.
3.3.2 Installing and charging the indoor unit
battery
A. Open the battery cover on the back of the unit.
B. Check the label on the battery for the correct orientation.
C. Insert the battery and place back the battery cover.
D. Insert the micro USB adapter to charge the battery.
E. Charge the battery completely before using the monitor on battery
power alone.

3.3.3 Charging outdoor unit battery

The outdoor unit (doorbell) can be operated on battery or AC power
(AC adapter not included). If operated on battery, it must be removed
in order to re-charge.
A. Remove the screw holding the front cover.
B. Remove the front cover.
C. Press the metal lever and pull out the battery pack.
D. Re-charge the battery by using the micro USB charge adapter
supplied for the monitor.
E. After charging: Insert the battery into the outdoor unit.
8
F. Place the front cover.
G. Fasten the screw holding the cover in place.

3.3.4 Installing a MicroSD card (Not included)

To record video, a MicroSD card is required.
A. Remove the battery cover and the battery of the indoor unit. (see
section "Installing and charging the monitor battery")
B. Open the MicroSD card cradle by sliding it. (see marking on cradle
for direction)
C. Insert the MicroSD card into the cradle with pins facing down.
D. Close the cradle and slide it to the closed position. (see marking
on cradle for direction)
3.3.5 Connecting AC power to the outdoor
unit (doorbell) (adapter not included)
The outdoor unit is portable and can be used on battery power or AC
power. A standard micro USB charger can be used as AC adaptor.
To connect the AC terminal blocks, you will need the following tool:
ü A small flat head screw driver.
A. ORANGE terminal block: Loosen the terminal screws.
B. With the terminal facing you: Insert the (+) wire on the left and the
(-) wire on the right.
C. Fasten the terminal screws.
D. Connect the terminal block to the outdoor unit.
E. Turn the unit on by setting switch 2 to "Power on".